Search results

  1. Y

    M113 E500 runs cool on a run and hot in traffic

    Yes I might have to try that along with a coolant flush as it looks due for a change. There is also some slight play in the water pump pulley with you wriggle it up and down.
  2. Y

    M113 E500 runs cool on a run and hot in traffic

    They cut in after 93C. In the summer in traffic it creeps up towards a high of 95, 96 and drops down to a low of 88-90 on the motorway. In the winter its a high of 89C in traffic and a low of 67C on the motoway
  3. Y

    M113 E500 runs cool on a run and hot in traffic

    Hi I have M113 E500 that seems to get up to 93c in heavy traffic but once you get on the motorway its reads a low down to 67c. I have replaced the original thermostat with a 87c Vemo thermostat and nothing has changed. There is no coolant loss, the heaters blow hot and the electric fans are...
  4. Y

    Calibration Full Airmatic S211

    Hi can anyone tell me how to calculate the inclination angle values? The car is sitting very low after some suspension work. Plus the nsr is quite a bit lower than the osr. I do know the nsr air spring leaks overnight but if I can get the correct ride height first. I'm using a Otofix scanner...
  5. Y

    Correct brake fluid for SBC

    Mercedes mention it needs 3L brake fluid for the procedure. Works out cheaper.
  6. Y

    Correct brake fluid for SBC

    Just found out its DOT 4 Plus on the lid. Febi do 5 litres that meets Mercedes spec...
  7. Y

    Correct brake fluid for SBC

    Hi is DOT 4 ok for SBC brakes on a 211 or will I have to get DOT 4 Plus? Thanks
  8. Y

    Smart 451 CDI 45HP Limp Mode EGR

    Hi I have a Smart 451 45HP and it goes into LIMP mode after a minute of running. I'm getting code P0401 Flow Insufficient Detected has been detected. I've cleaned out the EGR and mixer tube but the problem still persists. The EGR is not siezed. Does anyone have a clue what the issue could be...
  9. Y

    722.9 sump leak after service

    Thanks. Its seems to have mostly stopped the leak after I nipped the bolts . Fingers crossed it stays like that.
  10. Y

    722.9 sump leak after service

    Hi guys my E500 is on axle stands at the moment. After a day I noticed the whole pan was wet. I did replace the gearbox oil and filter and fitted new bolts torqued 4nm then 180 degrees. I nipped the bolts again and the leak has appeared again. Because it looks like I have to drain the oil and...
  11. Y

    W211 Rear diff output seal

    Thanks will try that.
  12. Y

    W211 Rear diff output seal

    Hi guys has anyone replaced the rear diff output seals before? Mine is leaking on one side and I have to replace the ABS reluctor rings and both sides so its a good opportunity to pull the driveshaft out.
  13. Y

    W211 dynamic seat pump reservoir line?

    Hi I have just replaced the impeller in my dynamic seat pump motor. Everything is back together but there seems to be a air line coming from the reservoir that I can't see where it connects to? Seat functions work except pulse red light flashes I'm guessing because of a lack of pressures.
  14. Y

    Dynamic seat pump w211 impeller

    I have take out my non functioning Dynamic seat pump and found out the impeller has shattered. I can see replacement impellers for 220, 230s etc but none for the 211. The pump looks identical. I'm wondering if anyone knows if the graphite impeller is the same? Aramox Vacuum Pump Impeller, PSE...
  15. Y

    W211 Parktronic no voltage to the sensors

    It magically works again guys.
  16. Y

    W211 Parktronic no voltage to the sensors

    Hi guys, My Parktronic was working before but was fiddling around swapping a front sensor and now when I turn the ignition on, the lights on the display light up then switch off. The Parktronic button is not off but when I select reverse or drive no sound or lights appear on the display. When I...
  17. Y

    Engine pictures, could you spot anything wrong?

    I'm confused what did they do for £4500?
  18. Y

    Engine mounts W211 320 CDI OM648 Febi vs Lemforder

    You can feel harmonic vibrations on idle and when you lean on the torque. Also the are visually cracked and sunk.
  19. Y

    Engine mounts W211 320 CDI OM648 Febi vs Lemforder

    Thanks guys. I will go Lemforder as I don't want lay on my back twice.
  20. Y

    Engine mounts W211 320 CDI OM648 Febi vs Lemforder

    I know this is a touchy subject. I don't want to start another war. Its Lemforder vs Febi. Ignore main dealer.

Avantgarde Automotive, Mercedes-Benz and SLR McLaren specialists. Service, repairs, diagnosis and motorsport preparation.
Unit 14 Hither Green Trading Estate, Clevedon, Somerset, BS21 6XU Tel: 01275 217270 Email:steve@avantgarde-automotive.co.uk
www.avantgarde-automotive.co.uk
Top Bottom