Search results

bosch stuff used to be quite good at backwards compatibility

trace the wiring from the door switch?

if it's an option there should be a code for it? on the plaque thing?

i would test the fuel pump and relay i think. won't start if the pump isn't running. how old is fuel filter?... must get round to doing mine soon...

hi just reading up on testing the ELR relay, it says apply 12V across Y22 - idling speed increases - BUT - it says do not exceed 3 sec or actuator will be damaged! Bit nervous about breaking this, it doesn't say which way round to apply the Voltage - the connector is a 'one way round ' one...

Hi bit confused about my 300TD cooling.... never had a Diesel before so not sure what's normal! Car seems to take forever to warm up compared to my 230TE! Tested the coolant sensor, seems fine so I'm going to replace the thermostat, although apparently it was replaced a couple of years...

hi after being advised copper fuses are a worthwhile improvement over the nasty aluminium ones I had a good search - but can't find a stockist! Does anyone have a link?

http://forums.mercedesclub.org.uk/album.php?albumid=165&pictureid=1110 Well the story is - reversing up hill in a tiny carpark (due to some numptys' bimmer parked like a 3 year olds tricycle...), big bang, no more go - looks under the car to see the above mess. Also picked up a snapped bolt...

hi been doing a bit of digging, suspect my tach/tickover problem is down to a faulty speed sensor, but I couldn't find the connector (L3x), or the sensor itself :Oops: so tested through the diagnostic port - presumably the resistance should still be same-ish, 2 k Ohm? -...

hi my 1993 300TD appears to have a problem with air con - but not a usual one... A/C doesn't work (unsurpising..) but neither does tacho, temp gauge is wildly erratic and the transmission seems...woolly (but it does need a throttle cable fitting, which may sort that) Current set up involves a...