Removing Upper Balljoint Arm!!!!!!

slaterjas

New Member
Joined
Feb 28, 2009
Messages
4
Reaction score
0
I have a 300se 126 Need to replace the Upper Balljoint arm. Undone the balljoint, taken off the rubbers from anti roll/steady bar? which goes through. There is now one long bolt which holds arm on reached from inside the engine compt. I thought it would simply knock through - but it doesn't any ideas????? Help appreciated
 

paganene

New Registration
Joined
Sep 5, 2007
Messages
1
Reaction score
0
Hi slaterjas, try turning bolt to free may be rusted, then put nut back on and try to hammer out, good luck.
 
OP
S

slaterjas

New Member
Joined
Feb 28, 2009
Messages
4
Reaction score
0
  • Thread Starter
  • Thread starter
  • #3
Thanks for reply eventually had to use hacksaw blade and saw through both sides of the bolt it was completely rusted into the bush!!
 


Chris Knott Insurance, see oursticky posts here!
www.ckinsurance.co.uk
Top Bottom