Isaachunt
Member
Changing the crush washers on my 3L v6 2010 c350 injectors today due to blow back issues, just wondering what Torque setting the clamp bolt should be set to? Can any one help?
V6 c350 injector torque setting
- Thread starter Isaachunt
- Start date
mioba
Senior Member
- Joined
- Feb 19, 2006
- Messages
- 8,263
- Reaction score
- 4,977
- Location
- Nottingham and Köln
- Your Mercedes
- W124/E200, W220/S320CDI, W205/C200, W251/R350CDI 4Matic
doubt the torque settings are in the manual supplied with the car.
You would need WIS or something like a Haynes.
You tube vids are often good as its mentioned in the videos sometimes.
You would need WIS or something like a Haynes.
You tube vids are often good as its mentioned in the videos sometimes.
Blobcat
Moderator
- Joined
- Feb 8, 2006
- Messages
- 40,156
- Reaction score
- 29,795
- Location
- Grange Moor
- Your Mercedes
- R171 SLK280, Smart R451, Land Rover 110 County SW, 997 C2S, R1250 GSA TE 40th, CBR600FP
- Moderator
- #3
7Nm+90deg+90deg
A couple of threads for you.
forums.mercedesclub.org.uk
forums.mercedesclub.org.uk
A couple of threads for you.
Injector hold down bolt
I've justr received the Laser kit (about time too), in the instructions it says torque should be hand tight + 90 degrees, or am I reading it wrong.
110 cdi injector bolts
Good evening all and hello. I am new to here and hope someone can help. I have just bought a vito 110 cdi as a non runner. It had been taken to an independent for the injector seals to be replaced, they were done and then it wouldn't start. Any ideas on this ?? The next problem I have is that...
