Rear Pads

[bbrinkw]

Hi, the rear pads are worn and i would like to replace them myself. Is this a straight forward job?
Bill
C200 P reg, 100,500 miles.

 

[television]

Dead simple, you will need a 7mm alen key to unbolt the caliper, as it has to be taken off to change them as it is the sliding shoe type of brake

http://www.detali.ru/cat/oem_mb2.as...417717.418&CT=F&cat=44V&SID=42&SGR=045&SGN=02

 

[Ellsy Tanners]

On a 202, all that is required is the two pins ( number 8 in malcolms link) to be knocked out and then pads can be removed.

Push back pistons and a clean up and all is good.

 

[television]

On a 202, all that is required is the two pins ( number 8 in malcolms link) to be knocked out and then pads can be removed.

Push back pistons and a clean up and all is good.

you are correct of coarse too many post today and I am going funny in the head

Thanks

 

[FIBAMAN]

The old uns are almost always right bill, dead easy, about 20mins per side, inc changing disc if necessary (used to get over 50k out of mine) Check pins, if they are badly corroded I would fit new ones as they only cost washers.