Search results

Attached is the wiring diagram. The later r230s (after 2007) have the auto tilt up.

The pump is good, the highest pressure requirement is to pull the boot shut, the boot unlock requires the same pressure as the doors. The boot release works by the PSE pump sending pressure AND a 12V signal to the valve (Y65/3) in the latch, the pressure then goes to the black "puck" in the...

Ian, here is a solution, from that well known supplier of "illegal" goods ... Halfords ;) You can use any LED bulb. Halfords 501 LED resistor kit 719249

Here you go.

gazbiker, Hold on a minute, just before you go pulling you car apart! The PSE pump does cycle on now and again, this is normal operation. It runs each time you lock / unlock the car, each time you open / close the boot and will cycle when you have the "massage" seats on (if you have them) or...