First start after winter storage. How can the ignition be disabled without pulling spark plug wires?

[MGC]

Hello,

I have a low mileage 1999 W202 C200 (M111 engine) that I don't drive in winter.

Normally, after over three months of Winter, I turn the engine over with the spark plug cables disconnected in order to circulate oil for the bearings before reconnecting the cables for the first start.

The reason I go to this length, which involves removing a few components to get to the spark plugs, is that I cannot determine if there is a single fuse or more easily accessible connector that can be opened that uniquely feeds power to the ignition system.

Might anyone know of a simpler method of disabling the ignition, but not the starter motor?

Thank you,
Michael

 

[LostKiwi]

Disconnect the injectors or fuel pump.

 

[MGC]

Disconnect the injectors or fuel pump.

Thank you, I will give that a try.

 

[M80]

Is there a fuel pump relay?
Or an engine management relay.

 

[DREAMER NO2]

Welcome MGC to the forum . Nice to see you in that nice car yesterday .

 

[MGC]

Welcome MGC to the forum . Nice to see you in that nice car yesterday .

Good to see you too. Had it out for a spin with my lady today, perfect weather. Have a great weekend!

 

[sonic]

My E350CDI comes out of hibernation on 1st April.

 

[DREAMER NO2]

MGC Enjoy your run out . Dont get going through any water to muck it up .
sonic My car is still under wraps ,i understand next week is going to be rather wet and cold .,so another week wont both me .