PCV system - Blow-by

Status
Not open for further replies.

Vronsky

Member
Joined
Jun 30, 2002
Messages
19
Reaction score
0
Location
The Netherlands
Dear All.
Can anyone tell me where I can find the PCV valve or filter on my 200E (W124 - 1991)? I notice lots of oil around the oilfiller cap, and I suspect that the crank case breathing system is not working properly.

Thanks,
Vronsky
 
OP
V

Vronsky

Member
Joined
Jun 30, 2002
Messages
19
Reaction score
0
Location
The Netherlands
  • Thread Starter
  • Thread starter
  • #5
PCV system

Thanks for the reply Andy,
Sorry, should indeed have mentioned it first time, but the garage replaced the cap with a new one at the last service with no improvement: oil still comes out.

Any idea?

Thanks
 
OP
V

Vronsky

Member
Joined
Jun 30, 2002
Messages
19
Reaction score
0
Location
The Netherlands
  • Thread Starter
  • Thread starter
  • #6
PCV system

Thanks for the reply Andy,
Sorry, should indeed have mentioned it first time, but the garage replaced the cap with a new one at the last service with no improvement: oil still comes out.

Any idea?

Thanks
 
OP
V

Vronsky

Member
Joined
Jun 30, 2002
Messages
19
Reaction score
0
Location
The Netherlands
  • Thread Starter
  • Thread starter
  • #8
PCV system

Hi Andy,
Engine has 110K mileage, not likely worn, but I'll check the filter for sure. Returning to my earlier question: can you point me where the crack case ventilation valve (or filter, don't know which) is located on the engine? Still think there's the problem.
Thanks.
 
Status
Not open for further replies.


GAD was founded in 2009 where we developed bespoke ECU Remapping software for motorsport clients, moving forward, we have extended to road vehicles for both performance and economy,
contact GAD Tuninghttp://www.GADTuning.co.ukto discuss your requirements.
Top Bottom