w211 LCD, dashes on mileage place

[ziko]

Hi,

On display only dashes where should be mileage.
No one touched dash, car was on service about ABS/BAS/ESP error and SRS error.
ABS was defective sensor and SRS was defective seat occupation sensor... that all repaired, bu costumer noticed that only trip mileage shown, on place where should me total mileage only - - - - - - dashes


Regards

 

[Cole@MBS]

That only happens when you have star connected, normally while doing brake fluid change, or working on SBC once you recycle ingition it should have cleared. What did you use to clear the fault codes????

 

[Cole@MBS]

..... and welcome to the forum!

 

[ziko]

Yes I had STAR connected to clear errors...
How can fix this problem now, any suggestion?


Thanks


Ziko

 

[Cole@MBS]

You need to go into ICM and check what the mileage is showing in the assist. Also, check in the engine ECU what the current mileage is in there.

Only ever seen this happen while doing a brake bleed or a air in system check on SBC

This certainly is a new one on me!

 

[type49]

Agree with SAM here, only happens when SBC has been exited incorrectly. I would try going back into SBC, re-activate & then come back out following exit instuctions - DONT just terminate program.

 

[ziko]

Look, situation was like this:
Car was in other service, i was go there to make diagnosis with STAR, and found left front sensor DTC. Airbag I think not problem, because occupation sensor i did myself next day. But for ABS sensor, other services do that, so I not know what he did to make ABS ok (maybe he made something in SBC...)

Is problem was , as you both said in SBC, how to resolve than this?


wbr

 

[ziko]

Solved...

This car has some problems while make diagnostic, couldn't perform QUICK SCAN, also must reconnect diag connector several times until enter some ECU for diag.
When enter IK DAS noticed me that LCD and buzzer is deactivated, and asked me to activate : yes/no, after yes all shows on LCD

Then entered SBC and saw that DAS make buzzer OFF , and mileage probably

Thanks for helping


Regards

Ziko

 

[Cole@MBS]

It can happen, glad its sorted!!!

 

[ziko]

Again some tips. I made cluster as I wrote above, but now started DIS SIM and see this info: see attachment image (flashing dashes instead total mileage shown).
Then need to go in adaptation/setting/ and learn the instrument to the drive authorization system, and all will be ok

that's will be all

Ziko