Jimmymac1961
New Member
- Joined
- Mar 12, 2024
- Messages
- 4
- Reaction score
- 0
- Your Mercedes
- Sprinter 210 CDi
Hello folks. My first question on the forum.
I need to run an electrical wire ( common connection for a forward/reverse switch).
Is there a route that can be taken to achieve this without removing the dash?
It's for an aftermarket electronic handbrake. I needed a new controller circuit board and it wires differently from the old one.
The old one had a 2 wire switch, the new one a 3 wire switch ( the extra common wire being the 3rd ).
I've tested it by taking the switch out of the dash and connecting it straight to the controller board. So now I need to route the wire from the switch to the controller.
I would appreciate any suggestions.
I need to run an electrical wire ( common connection for a forward/reverse switch).
Is there a route that can be taken to achieve this without removing the dash?
It's for an aftermarket electronic handbrake. I needed a new controller circuit board and it wires differently from the old one.
The old one had a 2 wire switch, the new one a 3 wire switch ( the extra common wire being the 3rd ).
I've tested it by taking the switch out of the dash and connecting it straight to the controller board. So now I need to route the wire from the switch to the controller.
I would appreciate any suggestions.
