R230 SL: Running cables from boot into cabin - best/easiest route?

[gez]

I have found that using the centre console power outlet to power my phone holder and dashcam interferes with DAB reception so I need to relocate my usb adapter to the boot power outlet. I'm also installing a reversing camera and rear dashcam.
So I have a number of cables to route from the boot into the cabin.
I had a first pass go and found a route but it proved too close to the roof mechanism hinges and would likely snag the cables over time so I decided to back off from that idea.
Rather than attack the trim until I find a gap I'm sure others have done this and might have recommendations?

 

[ajlsl600]

Try the sills and following the harness and can wiring. Ensure you are well shielded to avoid interference with existing.

 

[gez]

It's getting to the sills that is the problem.
I will have no problem in routing the cables once I can get them through the boot bulkhead into the cabin.

 

[ajlsl600]

I seem to remember? The outer sills come off, can you not see a route then? If existing cabling if entering and departing there.

 

[ajlsl600]

Is!!! Finger in pencil sharpener time a f gain..

 

[gez]

Thanks, I'll check it out and post some pics when I find a route.