Hi
Hope all is well,
W123 200 1979 M115
Ok getting an oil leak from the distributor housing/bracket/shaft… oil spirting out of the base. I thought it was the o ring on the distributor but it doesnt leak from its clamp/shaft. (See picture green ticks)
Thinking pressure build up in crankcase...
Good Evening
My car is a 2006 E280 (pre-facelift)
The air conditioning was not cooling the car but there were no errors reported.
The B12/2 pressure was 3 bar with the engine off and rose to 5 bars with the engine running at idle.
I contacted the local Mercedes dealer who recharged the air...
Hey guys I’ve been having issue with my boot soft close and also the central locking not working. On my 2003 SL350 (R230)
In another thread I went through everything I’ve done so far including sealing every single possible leak from the PSE to the boot actuator.
I’ve also stripped down the...
I spent ages searching on line for the location of this sensor and also got some unhelpful advice from an independent I did not know about my error code (P0109 Manifold Absolute Pressure/Barometric Pressure Circuit Intermittent) not making sense. There is a YouTube video of someone changing...
Hello
Owner of merc w211 e220 Cdi 2007
226k
I am having low fuel pressure issues.
Star diagnostic code 22e7
Check high pressure control ‘rail pressure too low’
When i open up the throttle (hard acceleration) going up a hill or on motorway, the engine light comes on and car goes into limp...
Hello
Owner of merc w211 e220 Cdi 2007
226k
I am having low fuel pressure issues.
Star diagnostic code 22e7
Check high pressure control ‘rail pressure too low’
When i open up the throttle (hard acceleration) going up a hill or on motorway, the engine light comes on and car goes into limp...
Hi all
I have just purchased a 2004 C Class 180 Kompressor. It is in great condition, low mileage and drives well.
After searching for a dip stick I worked out that the car measures its own oil level. It said add 1.5 litres which I did. Dash then read correct level.
A few questions...
Hi
Well I'm having fun with my OM642 as well. After changing endless bits in the last year for various fault codes that have cleared up those issues (such as exhaust back pressure sensor, lambda sensor, Air mass sensor, etc) I am currently left with:
2047 Rail Pressure monitoring via volume...
Hi all - have got some major work planned on the ABC system on my SL55 - valve block overhaul (x2), new accumulators, 1 x level sensor, fluid, filter etc.. but the only item I'm not (currently!) replacing is the Pressure Relief valve block. One of the symptoms I'm getting is an occasional...
This is my first post. I've found this site really useful so far.
I'm trying to replace the fuel filter on my W210 '02 Reg Diesel Automatic. I've read that to depressurise the fuel filter I need to run the engine then while its on remove the fuse to the fuel pump - this should cut out the...
Hi,
I've just purchased a new (second-hand) E320 CDi Sport '08 plate. As the weather is shockingly bad at the moment, I've not had a chance to run it since it was delivered this week.
I'm looking to invest in a set of new alloys and winter tyres. However, I've been unable to get a straight...
Hi all,
Have an odd problem with a C220 Diesel, won't start when cold unless easy start is sprayed into inlet, it will then start and run absolutley fine for hours - But once stopped will not re-start even when hot.
Believe its fuel pressure related just wondered if anyone knows what the...
Hi,
I wondered if anyone can advise if I need any specialist tools to replace a high pressure diesel pump on my Mercedes Sprinter.
My vehicle is actually in France and I would need to go with all tools / parts etc to carry out the repair.
Are there any timing issues or calibration...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.