rear bearing replacement by removing the whole wheel stative

[fritzone]

Hello everybody,

I had I want to change the rear wheel bearing and to do this I unscrewed the entire wheel stand, but it cannot be pegged out now, although it is not held by any screw and it should actually no longer be fixed. Anyone knows what to do? In the picture, my harmless attempt to pull it off.

 

[alexanderfoti]

Are you trying to remove the drive shaft from the center of the hub? If so, penetrating fluid and a dead blow hammer usually frees the.

 

[Uncle Benz]

They can be difficult. If you are replacing the wheel bearing anyway use some heat on it