NBurns
Senior Member
- Joined
- Jun 16, 2019
- Messages
- 1,080
- Reaction score
- 445
- Location
- Sunny Hampshire by the sea
- Website
- www.facebook.com
- Your Mercedes
- A180 CDI AVANTGARDE SE CVT,169.007, 2009
Torque settings for the S203 OM646.963 Engine exhaust manifold
Just rebuilding my Mercedes now after having to replace the turbocharger (major failure!!). Oil and carbon deposits everywhere plus an injector seal and holder failure. i.e. After removing the injector finally and retrieving the washer, the fact it was only slightly black did not convince me it was just the washer failure. I agree that black death is also caused by a design fault with the holder and bolt being the only way to hold down the injector. Anyway, I mistakingly undid the exhaust manifold bolts thinking I needed to take this off to get the turbo out,....I didn't. So now I need to do up the bolts again however as they are major bolts they will need torquing. Thus I need the torque settings for these and if possible all the bolts that need torquing on my Mercedes Benz C220 CDI Classic SE S203.208, OM646.963 Please anyone?
Just rebuilding my Mercedes now after having to replace the turbocharger (major failure!!). Oil and carbon deposits everywhere plus an injector seal and holder failure. i.e. After removing the injector finally and retrieving the washer, the fact it was only slightly black did not convince me it was just the washer failure. I agree that black death is also caused by a design fault with the holder and bolt being the only way to hold down the injector. Anyway, I mistakingly undid the exhaust manifold bolts thinking I needed to take this off to get the turbo out,....I didn't. So now I need to do up the bolts again however as they are major bolts they will need torquing. Thus I need the torque settings for these and if possible all the bolts that need torquing on my Mercedes Benz C220 CDI Classic SE S203.208, OM646.963 Please anyone?